This haunted moon crochet table runner is a dramatic Halloween runner assembled from three ivory crescent moons, three deep-purple spiderweb medallions, three black haunted-house silhouettes with glowing-orange window insets, three pumpkin motifs, and branching black lace connectors. The construction is designed specifically for the named project rather than adapted from a generic table-runner template.
Three repeating Halloween clusters are built separately. Each cluster combines one ivory crescent, one purple spiderweb, one black haunted house, and one orange pumpkin; the clusters alternate direction and are joined vertically with branching black chain arches before a final stabilizing corded edge is added.
Why You’ll Love This Project
The crescent moon motifs, spiderweb lace, applique assembly create a distinct table accent with clear checkpoints, practical drape, and strong handmade texture.
Materials
- Approximately 460 yards black DK cotton yarn
- Approximately 300 yards ivory DK cotton yarn
- Approximately 260 yards deep-purple DK cotton yarn
- Approximately 180 yards pumpkin-orange DK cotton yarn
- Approximately 40 yards moss-green DK cotton yarn
- Approximately 30 yards golden-yellow DK cotton yarn
- Thirty locking stitch markers
- 3.5 mm crochet hook
- Yarn needle
- Scissors
- Tape measure
- Blocking mats and rustproof pins
Gauge, Measurements, and Planning
Make a generous swatch in the main stitch. The target gauge is one blocked crescent moon measures 8 inches tall by 6 inches wide; change hook size if needed before beginning the full runner.
Make and wash a gauge swatch before beginning. Measure only after the swatch is completely dry. If the stitch width differs, change hook size rather than pulling the working yarn tighter. Keep a written count at the end of every section so the finished edges remain balanced and the assembly points line up.
Abbreviations and Special Stitches
- ch: chain
- dc: double crochet
- hdc: half double crochet
- sc: single crochet
- sl st: slip stitch
- st(s): stitch(es)
- BLO: back loop only
- yo: yarn over
Special stitch guidance: Crescent shaping uses graduated stitches on one side of a ring and slip stitches on the inner curve. Web spoke: work a long treble crochet into the marked center space. Branch picot: chain 4, slip stitch in the second chain, then slip stitch in the next two chains. Window inset is a small golden mesh rectangle sewn behind the black opening.
Before You Begin
- Maintain the stated 12-stitch construction count at every checkpoint.
- Beginning chains count only where explicitly stated.
- Block components before final assembly or border work.
- Use US crochet terminology throughout.
Instructions
Crochet Three Ivory Crescent Moons
Count carefully and compare the work with the finished measurements.
- Motif Round 1: With ivory, make a magic ring and work 12 sc into it. Join. (12 sts)
- Rounds 2–4: Increase evenly across seven stitches while working slip stitches across the remaining five to begin the crescent opening.
- Rounds 5–8: Build graduated sc, hdc, dc, and treble groups along the outer curve; decrease one group at each tip to sharpen both points.
- Edge each moon with ivory sc and three evenly spaced picots, then block to 8 by 6 inches. Make three.
Make Three Purple Spiderwebs
Count carefully and compare the work with the finished measurements.
- With deep purple, work 12 sc into a magic ring and join. (12 sts)
- Round 2: Work twelve web spokes using alternating chain spaces and long treble crochet anchored into the center ring.
- Rounds 3–6: Connect the spokes with progressively longer chain arches, keeping all twelve spokes evenly tensioned.
- Finish each spoke with a pointed chain-3 picot and block every web to 8 inches across. Make three.
Crochet Haunted Houses and Pumpkins
Count carefully and compare the work with the finished measurements.
- For each haunted house, work a 32-stitch black rectangle for 22 rows, then shape three stepped roof peaks over the final six rows.
- Add two narrow towers, crooked branch extensions, and three open window spaces; sew small golden-yellow mesh rectangles behind the windows.
- For each pumpkin, work 12 orange hdc into a ring, increase to 48 stitches over four rounds, and use surface slip stitches to define six ribs.
- Add a moss-green stem and embroider a simple black jack-o-lantern face. Make three houses and three pumpkins.
Assemble the Haunted Moon Runner
Count carefully and compare the work with the finished measurements.
- Arrange three clusters vertically, alternating the moon and web from left to right while centering one haunted house beneath each pair.
- Place one pumpkin beside each house and pin every motif before joining.
- Connect touching motifs with black chain-5 arches and branching picot stems, adding secondary joins wherever a gap exceeds 1 inch.
- Work a narrow padded-slip-stitch cord along the central joins and block the complete runner to 14 by 52 inches.
Assembly and Shaping
Follow the project-specific assembly sequence for joined halloween motif runner. Pin or mark every component before joining and keep the layout centered inside the border.
Lay every component on a flat surface before joining. Match the marked centers first, then divide each remaining edge into equal sections. Work through both layers with consistent tension and pause after each section to check that the fabric lies flat. This measured approach prevents twisting and keeps decorative details facing the intended direction.
Finishing
- Weave every tail through matching stitches and reverse direction once.
- Inspect all joins, motif anchors, and border corners.
- Block to 14 inches wide by 52 inches long.
- Allow the runner to dry completely before styling.
For a polished result, weave each tail through several same-color stitches, reverse direction once, and trim only after the fabric has been gently stretched. Block to the listed dimensions without flattening textured stitches. Inspect joins, borders, straps, and decorative pieces before the project is used or gifted.
Helpful Tips
- Use locking markers at every construction checkpoint.
- Record row and motif counts as you work.
- Keep joins and color changes relaxed enough to lie flat.
- Photograph the complete layout before final assembly.
Good lighting and a contrasting stitch marker make counting much easier. If a section looks uneven, compare the current count with the previous checkpoint before continuing. Fixing one missed stitch early is faster than compensating later, and it preserves the measurements used by the assembly instructions.
Frequently Asked Questions
Can I omit the jack-o-lantern faces?
Yes. Plain ribbed pumpkins create a softer autumn look while keeping the same assembly.
Can I make the runner shorter?
Yes. Use two complete clusters and block the finished piece to approximately 36 inches long.
How do I keep the openwork motifs flat?
Block every moon and web separately before arranging the clusters, and keep the joining arches relaxed and equal in length.
Conclusion
The finished haunted moon crochet table runner showcases crescent moon motifs, spiderweb lace, applique assembly in a construction that matches the project from foundation through border.
Printable Crochet Pattern Card
Project: Haunted Moon Crochet Table Runner
Skill level: Intermediate Hook: 3.5 mm Yarn: DK
Finished size: Approximately 14 inches wide by 52 inches long
Card Materials
- Approximately 460 yards black DK cotton yarn
- Approximately 300 yards ivory DK cotton yarn
- Approximately 260 yards deep-purple DK cotton yarn
- Approximately 180 yards pumpkin-orange DK cotton yarn
- Approximately 40 yards moss-green DK cotton yarn
- Approximately 30 yards golden-yellow DK cotton yarn
- Thirty locking stitch markers
- 3.5 mm crochet hook
- Yarn needle
- Scissors
- Tape measure
- Blocking mats and rustproof pins
Card Instructions
- Crochet Three Ivory Crescent Moons: Motif Round 1: With ivory, make a magic ring and work 12 sc into it. Join. (12 sts) Rounds 2–4: Increase evenly across seven stitches while working slip stitches across the remaining five to begin the crescent opening. Rounds 5–8: Build graduated sc, hdc, dc, and treble groups along the outer curve; decrease one group at each tip to sharpen
- Make Three Purple Spiderwebs: With deep purple, work 12 sc into a magic ring and join. (12 sts) Round 2: Work twelve web spokes using alternating chain spaces and long treble crochet anchored into the center ring. Rounds 3–6: Connect the spokes with progressively longer chain arches, keeping all twelve spokes evenly tensioned. Finish each spoke with a pointed chain-3 picot and block ever
- Crochet Haunted Houses and Pumpkins: For each haunted house, work a 32-stitch black rectangle for 22 rows, then shape three stepped roof peaks over the final six rows. Add two narrow towers, crooked branch extensions, and three open window spaces; sew small golden-yellow mesh rectangles behind the windows. For each pumpkin, work 12 orange hdc into a ring, increase to 48 stitches over four round
- Assemble the Haunted Moon Runner: Arrange three clusters vertically, alternating the moon and web from left to right while centering one haunted house beneath each pair. Place one pumpkin beside each house and pin every motif before joining. Connect touching motifs with black chain-5 arches and branching picot stems, adding secondary joins wherever a gap exceeds 1 inch. Work a narrow padded-
Finish: Check every count, weave in all ends, block to measurement, and inspect each join.
